当前位置: 首页 » 政策法规 » 国外法规 »§146.3 罐装果汁相关定义(Definitions)

§146.3 罐装果汁相关定义(Definitions)

扫描二维码 分享好友和朋友圈
放大字体  缩小字体 2011-09-08 07:15:54  来源:GPO  浏览次数:3870
核心提示:本节定义了罐装果汁相关的术语:玉米淀粉糖浆是玉米淀粉不完全水解得到的澄清、浓缩的水溶液产品;葡萄糖是水解淀粉后的水合或无水的精制单糖;糖是指精制蔗糖;葡萄糖浆是食用淀粉不完全水解得到的澄清、浓缩水溶液;合格指除额外提供标准外,产品按本节规定的抽样和验收程序进行测定后,必须符合质量要求和容器填充要求,同时对抽样和验收程序中相关的批、批量、抽样量、样品单位、缺陷品等方面作了说明。
发布单位
FDA
FDA
发布文号 暂无
发布日期 暂无 生效日期 暂无
有效性状态 废止日期 暂无
备注 本节定义了罐装果汁相关的术语:玉米淀粉糖浆是玉米淀粉不完全水解得到的澄清、浓缩的水溶液产品;葡萄糖是水解淀粉后的水合或无水的精制单糖;糖是指精制蔗糖;葡萄糖浆是食用淀粉不完全水解得到的澄清、浓缩水溶液;合格指除额外提供标准外,产品按本节规定的抽样和验收程序进行测定后,必须符合质量要求和容器填充要求,同时对抽样和验收程序中相关的批、批量、抽样量、样品单位、缺陷品等方面作了说明。

      更多关于罐装果汁的法规,请详见美国FDA 21 CFR 第146部分关于罐装果汁的法规汇总

  § 146.3   Definitions.

  For the purposes of this part:

  (a) The term corn sirup means a clarified, concentrated, aqueous solution of the products obtained by the incomplete hydrolysis of cornstarch, and includes dried corn sirup. The solids of corn sirup and of dried corn sirup contain not less than 40 percent by weight of reducing sugars calculated as anhydrous dextrose.

  (b) The term dextrose means the hydrated or anhydrous, refined monosaccharide obtained from hydrolyzed starch.

  (c) The term dried glucose sirup means the product obtained by drying glucose sirup.

  (d) The term glucose sirup means a clarified, concentrated, aqueous solution of the products obtained by the incomplete hydrolysis of any edible starch. The solids of glucose sirup contain not less than 40 percent by weight of reducing sugars calculated as anhydrous dextrose.

  (e) The term invert sugar sirup means an aqueous solution of inverted or partly inverted, refined or partly refined sucrose, the solids of which contain not more than 0.3 percent by weight of ash, and which is colorless, odorless, and flavorless, except for sweetness.

  (f) The term sugar means refined sucrose.

  (g) Compliance means the following: Unless otherwise provided in a standard, a lot of canned fruits shall be deemed in compliance for the following factors, to be determined by the sampling and acceptance procedure as provided in paragraph (h) of this section, namely:

  (1) Quality. The quality of a lot shall be considered acceptable when the number of defectives does not exceed the acceptance number in the sampling plans.

  (2) Fill of container. A lot shall be deemed to be in compliance for fill of container when the number of defectives does not exceed the acceptance number (c) in the sampling plans.

  (h) The sampling and acceptance procedure means the following:

  (1) Definitions —(i) Lot. A collection of primary containers or units of the same size, type, and style manufactured or packed under similar conditions and handled as a single unit of trade.

  (ii) Lot size. The number of primary containers or units in the lot.

  (iii) Sample size. The total number of sample units drawn for examination from a lot.

  (iv) Sample unit. A container, a portion of the contents of a container, or a composite mixture of product from small containers that is sufficient for the examination or testing as a single unit.

  (v) Defective. Any sample unit shall be regarded as defective when the sample unit does not meet the criteria set forth in the standards.

  (vi) Acceptance number ( c ). The maximum number of defective sample units permitted in the sample in order to consider the lot as meeting the specified requirements.

  (vii) Acceptable quality level ( AQL ). The maximum percent of defective sample units permitted in a lot that will be accepted approximately 95 percent of the time.

  (2) Sampling plans:
 

Lot size (primary containers) Size of container
n 1 c 2
net weight equal to or less than 1 kg (2.2 lb)
4,800 or less 13 2
4,801 to 24,000 21 3
24,001 to 48,000 29 4
48,001 to 84,000 48 6
84,001 to 144,000 84 9
144,001 to 240,000 126 13
Over 240,000 200 19
net weight greater than 1 kg (2.2 lb) but not more than 4.5 kg (10 lb)
2,400 or less 13 2
2,401 to 15,000 21 3
15,001 to 24,000 29 4
24,001 to 42,000 48 6
42,001 to 72,000 84 9
72,001 to 120,000 126 13
Over 120,000 200 19
net weight greater than 4.5 kg (10 lb)
600 or less 13 2
601 to 2,000 21 3
2,001 to 7,200 29 4
7,201 to 15,000 48 6
15,001 to 24,000 84 9
24,001 to 42,000 126 13
Over 42,000 200 19



  1 n =number of primary containers in sample.

  2 c =acceptance number

食品伙伴网提供标准法规解读、舆情监控、合规咨询、申报注册等服务。
电询:0535-2129301
QQ:2891238009
食品标法圈
实时把握食品标法动态
请扫码关注食品标法圈

声明:

① 凡本网所有原始/编译文章及图片、图表的版权均属食品伙伴网所有,如要转载,需注明“信息来源:食品伙伴网”。
② 凡本网注明“信息来源:XXX(非食品伙伴网)”的作品,均转载自其他媒体,转载目的在于传递更多的信息,并不代表本网赞同其观点和对其真实性负责。
※ 邮箱:law#foodmate.net(发邮件时请将#换成@) QQ:139307733

 
 
[ 政策法规搜索 ]  [ 加入收藏 ]  [ 告诉好友 ]  [ 打印本文 ]  [ 关闭窗口 ]

 

 
 
按分类浏览
国家法规 (11358) 国外法规 (3603)
地方法规 (39741) 法规动态 (85)
法规解读 (2623) 其他法规 (506)
推荐国外法规
点击排行
按国家或地区浏览

法规中心  关于我们  广告业务  联系我们  信息服务

Processed in 0.323 second(s), 10 queries, Memory 4.48 M